No power supply available
Check the voltage supply to the operator and the controls

Safety circuit interrupted
Alle Komponenten des Sicherheitskreises prüfen und ggf. schließen

There is no safety edge device connected
Install and connect a safety edge device

The safety edge device is faulty
Check the safety edge device and the spiral cable and/or transmission system

There is no drive-through photoelectric barrier or wire jumper connected
Connect a photoelectric barrier or jumper

Drive-through photoelecric barrier faulty
Check the photoelectric barrier

There is no safety edge device connected
​​​
Install and connect a safety edge device

The safety edge device is faulty
Check the safety edge device and the spiral cable and/or transmission system

There is no drive-through photoelectric barrier or wire jumper connected
Connect a photoelectric barrier or jumper

Drive-through photoelectric barrier faulty
CHeck the photoelectric barrier

The wireless transmission system connected is reacting to external interference
Remove the source of interference or alter the frequency

One of the (outdoor) command devices is lying under water
Replace the command device or dry it and reseal it

Excessive wear due to mechanical damage
Check the door system

One phase of the mains cable is not enabled
Check the voltage supply to the operator and the controls

Yes, but without a clear text display (LCD monitor) only the end positions can be programmed.
All other parameter settings can only be entered on the LCD monitor.

Exception: CS100 control - it is not possible to connect an LCD monitor to this control.

Short circuit in the 24V DC control voltage
Check all the components connected for a short circuit

The average delivery time for standard models of products is 10 working days.

The average delivery time for special versions of products is 20 working days.